Dante Firmware Update Manager (Legacy)

All KLANG products with built-in Dante interface can be updated over network from a computer running Audinate’s Dante Firmware Update Manager (macOS and Windows). Audinate offers a detailed description on the update tool (see link below) and we have summarized the basic procedure in the following. 

Please download and install the latest Dante Firmware Update Manager for macOS or Windows.

Download the Dante Firmware File for your product here.

1. Open the Dante Firmware Update Manager.
2. Enter your adminstator password if required, and choose your network interface.
3. Click on Next.

Click on Update Dante Firmware.

1. Click on Browse...
2. Select the Dante Firmware file for your KLANG product.
3. Option Override Device Matching.
   1. Normally you do NOT have to override Device Matchings.
   2. In case you can not find any KLANG devices in the following steps, please go back and set the checkbox for Override Device Matching once. (This has to be done once if you are updating from an older version where Klang was not written in capital letters. Updating to 1.1.x.x from 1.0.x.x requires to check this option once.)
4. Click on Next. (If you had to choose Override device matching click also on Yes)

1. Check the box to select your KLANG product’s Dante module to be updated.
2. Click on Start.

The KLANG specific firmware on the Dante module is usually uploaded in a few seconds. If the Dante software on the module is going to be updated, e.g. to support AES67 functionality, this may require a few minutes.

After the Firmware Update Manager is finished with the update, it shows a dialog. Please power off your KLANG device and turn it on again to ensure the latest/current firmware is loaded correctly. You can monitor the Firmware version in the Dante Controller. Please check the information carefully. It might also be good practice to save screenshots for future references.